Tiered Tray Hardware Kit 2 Sets Cake Tray Stand Handle Cupcake Dessert Plate Hardware Fitting Holder Rod Stand Handle for Cake Stand Wedding Party, 3-Tiers New Crown Gold/Silver

Specification:Material: Zinc AlloyConnecting Rod Size: 125x14mm/4.92"x0.55"(L*W)Top Rod Size: 120x41mm/4.72"x1.61"(L*W)Screw Length: 15mmPackage Content:2 Sets =1pcs Silver + 1pcs GoldNotice:1.1cm=10mm=0.39inch.2.Please allow 1-2mm error due to manual measurement and make sure you do not mind before ordering.3.Please understand that colors may exist chromatic aberration as the different placement of pictures.

• Hand-Tighten and Go: Thread the posts together by hand—no tools, no fuss, and you have a multi-tier stand ready in seconds
• Build, Use, Store Flat: Stack two, three, or more layers for the party, then break it down to flat pieces that slide into the tightest cabinet
• Holds the Weight, Hides the Bulk: Each joint locks solid under loaded plates, yet the whole thing tucks away neatly once the table is cleared
• More Than a Cake Stand: Great for cupcakes, fruit displays, retail merchandise, or any spread that needs a lift—wherever presentation counts, it fits right in
• Setup Tip for Steady Stacking: Start level and tighten from the bottom up; for heavier loads, keep the largest plate on the bottom for maximum stability